trc-025 seriesCfixed output and dimmable 25w switch mode led drivers constant current, long life electrical specifcations input voltage range: 120 - 277 nom. vac (90 - 305 v min/max) frequency: 50/60 hz nom. (47-63 hz min/max) power factor: >0.90 @ full load, 100v through 277v input current: 0.32 a @ 100vac, 0.15 a @ 220vac inrush current: 60.0 amps @ 230vac, 25c cold start effciency 85-85% typical @ maximum load maximum power: 25w line regulation: 3% load regulation: 5% turn-on time delay: 3s output protection: over-voltage, over-current, short circuit protection with auto recovery environmental specifcations minimum starting temp: -20oc maximum case temp. 89c storage temperature: -40oc to +85oc humidity: 10% to 100% cooling: convection sound rating: class a mtbf: 484,000 hours @ 25oc, 80% load, 110vac input on 2080 ma output model (mil-hdbk-217f) lifetime: 79,000 hours @ 45oc, 80% load, 110vac input on 2080 ma output model weight: 0.4 lbs. class 2: us/canada us only dimmable versions - product specifcations model number output current (ma) output voltage range (vdc) max. output power (w) typical effciency trc-025s035ds 350 24-72 25 84% trc-025s045ds 450 19-56 25 84% trc-025s062ds 620 13-40 25 83% TRC-025S070DS 700 12-36 25 83% trc-025s105ds 1050 8-24 25 82% trc-025s140ds 1400 6-18 25 81% trc-025s175ds 1750 5-14 25 81% trc-025s208ds 2080 4-12 25 80% constant current versions - product specifcations model number output current (ma) output voltage range (vdc) max. output power (w) typical effciency trc-025s035ps 350 24-72 25 84% trc-025s045ps 450 19-56 25 84% trc-025s062ps 620 13-40 25 83% trc-025s070ps 700 12-36 25 83% trc-025s105ps 1050 8-24 25 82% trc-025s140ps 1400 6-18 25 81% trc-025s175ps 1750 5-14 25 81% trc-025s208ps 2080 4-12 25 80% ? total power: 25 watts ? input voltage: 100-277 vac nom. ? ul dry & damp location rated ? ip66 ? high effciency ? high power factor rev 8-31-15 specifcations subject to change without notice. note: led drivers are designed and intended to operate led loads only. non-led loading may be outside the specifed design limits of our led drivers, and therefore cannot be covered by any warranty. if you desire to use our led drivers to operate non-led loads please contact us to discuss compatibility. thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com
pg 2 of 3 output red(+) black(-) input black (l) white (n) dimming control yellow (10v out) purple (1-10v in) green (gnd) wire specs: ac input: #18awg dc output: #18awg dimming control: #22awg safety and emc compliance cl ce l 8750 en 61347-1, en61347-2-13 en 55015 conducted emission en 61000-3-2 harmonic current emissions en 61000-3-3 voltage fuctuations and ficker derating curve load (%) 100 80 60 40 20 0 ambient temperature (c) -20 -10 0 10 20 30 40 50 60 70 trc-025 series 50% load pf power factor / load 60% 70% 80% 90% 100% 50% load thd thd / load 60% 70% 80% 90% 100% 1 20v a c 2 77v a c 1 20v a c 2 77v a c 0.50 0.55 0.70 0.65 0.60 0.75 0.90 0.85 0.80 0.95 1.00 0% 15% 10% 5% 20% 25% typical efficiency / load 75% 70% 80% 85% 90% 100% 95% normalized output voltage efficiency 60% 70% 80% 90% 100% 1 20v a c 2 77v a c thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com ssl solutions faster than the speed of light ?
pg 3 of 3 dimming control details parameters minimum typical maximum 10v output voltage 9.8 v 10 v 10.2 v 10v output source current -10 ma 2 ma absolute maximum voltage on the 0-10v input pin -2 v 15 v source current on 0-10v input pin 0 ma 1 ma the dimmer control is operated from either a potentiometer or from an input signal of 1 C 10 vdc. recommended implementations are provided below. o p tion 1 - potentiometer control 20k 1-10v input (purple) gnd (green) 10v output (yellow) 1-10v input (purple) gnd (green) 1-10vdc v op tion 2 - dc input trc-025xxxxds trc-025xxxxds vdim (v) normalized output current output current / potentiometer 0% 20% 40% 60% 80% 100% 0 1 2 3 4 5 6 7 9 8 10 vdim (v) normalized output current output current / dimming voltage 0% 20% 40% 60% 80% 100% 0 1 2 3 4 5 6 7 9 8 10 notes: 1. for the driver to operate properly, the load voltage must be maintained above the minimum voltage threshold (approx. 33% of the max. output voltage for any given model). 2. if the dimming voltage is varied from 10v down to 0v, the output current can be varied from 100% io down to 20-30% io. 3. do not connect the gnd of dimming to v(-) or earth ground; otherwise the led driver will not work properly . 4. if dimming is not required, connect yellow and purple leads together to get full current output (100%). 5. it is permissible to parallel driver outputs to achieve higher output currents. however, when doing so, it is not permissible to connect dimming control leads in parallel. 6. it is permissible to connect dimming control leads of multiple drivers in parallel to allow them to operate from a single 0-10v control. however, when doing so, it is not permissible to interconnect output leads (red and black) across drivers. trc-025 series thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com ssl solutions faster than the speed of light ?
|
